Google+
Parts & Upgrades

160F BRS Exclusive Low Temperature Thermostat Insert for MY 2009-2012 (DFI)

RND Engines RS Roller Bearing Kit

RND Roller Bearing IMS Retrofit kit is the only solution on the market that uses proper heat treated, 52100 bearing steel thrust surfaces on both sides and provides true thrust control integral to the bearing.

RS Roller Bearing KitT

160F BRS Exclusive Low Temperature Thermostat Insert for MY 2009-2012 (DFI)

$99.00

In stock

SKU: 102-200070

Professional installation is recommended using a coolant lift system to ensure no air locks in the cooling system. Fits MY09+ or later DFI engines

Description

Details

Did you know the factory thermostat doesn't start to even open until 186.8F and doesn't fully open until almost 210F? This causes hotspots inside your engine that can result in cracked heads and cylinder failures from overheating. Also, little known is the fact that oil temperatures usually run 10-15F higher than coolant temperature in engines equipped with oil to coolant heat exchangers. Installation of a 160F low temperature thermostat lowers coolant temperatures which lowers oil temperatures! Tiptronic cars further benefit from reduced ATF temperatures, resulting in crisper shifts and extended transmission life. All these benefits with no negative side effects like failed emissions testing, check engine lights, or poor cabin heating in cold climates. Our 160F low temperature thermostat is not available from any other vendor and features a calibrated, German-made 160F thermostat. It is calibrated to allow thermostat opening a full 20-25F degrees earlier than the factory thermostat. That means that the the low temperature thermostat is designed to be fully open by 180-185F, allowing for full flow to the cooling system to maximize cooling potential. The thermostat sold by LN Engineering is the only one used and recommended by Flat 6 Innovations and should be installed anytime a new Genuine Porsche water pump is installed, which should be replaced no later than 4 years or 50,000. Higher coolant temperatures can increase thermal efficiency and reduce emissions, sacrificing performance and longevity. This is especially important with the long drain intervals recommended by Porsche (which we do not recommend!). The principle behind lowering coolant temperatures (regardless of application) is that a cooler engine will have higher volumetric efficiency. Lower temperatures will also allow for more timing without detonation since the ECU is capable of changing timing based off of fuel quality and engine operating temperature. This can result in higher horsepower and better fuel economy as well.We recommend using genuine Porsche coolant along with Joe Gibbs CSP (Cooling System Protectant) and removal of the bumper cover to clean out radiators is required to maximize cooling performance at low speeds. Even if you have cleaned out your radiators, please be advised, some late-model cars do not report actual coolant temperature, so some users will not see any visible change in operating temperature when fitted with a 160F low temperature thermostat.

Additional

Additional Information

Brand No

Important Seller's Note

Products and services provided by Seller have the potential to substantially raise the torque and horsepower output of an engine. Additionally, high performance parts exert greater stress on engine components. Seller assumes no responsibility for injury or damage resulting from increased torque and horsepower output or failure of any components due to Seller's products and services. Seller urges that Seller's products not be used unless, after an engine has been modified with Seller's parts and services, the owner is able to operate safely, and is willing to accept responsibility for the effects Seller's products and services may have.

It is important to read, understand and accept our Sales and Limited Warranty Terms and Conditions. Privacy Policy can be found here.


Questions or comments? Feel free to contact us before ordering at 815.472.2939 or info@lnengineering.com