-
Billet Stainless Magnetic Drain Plug Porsche 914 912E (12 x 1.5) 021101195LN
SKU: 021101195LN
$21.79Upgrade your Porsche 914 amd 912E engine with a billet stainless magnetic drain plug (12 x 1.5mm) from LN Engineering and the Type 4 Store. Made in house at LN Engineering in Momence, IL, our USA made drain plug features a rare earth magnet and stainless construction. It's the finest drain plug money can buy. Includes one drain plug washer/gasket/seal (part number N 013 805 1). Before ordering, please verify which drain plug your engine needs; some may require a 12 x 1.5mm drain plug while others use a 14 x 1.5mm (which we also manufacture under part number N0297014LN). Learn More -
OEM Kolbenschmidt 10 mm Valve Adjusters
SKU: 08236
$85.60OEM Kolbenschmidt 10 mm Valve Adjusters - set of 8 Learn More -
Genuine Porsche 10mm Valve Adjuster Nuts
SKU: 08240
$49.45Genuine Porsche 10mm Valve Adjuster Nuts - set of 8 Learn More -
ARP 104-6006 Porsche 914, 912E, VW Type 4 1.7, 1.8, 2.0 Rod Bolt Kit
SKU: 104-6006
$164.99ARP 104-6006 Porsche 914, 912E, VW Type 4 1.7, 1.8, 2.0 Rod Bolt Kit Connecting Rod Bolts, High Performance Series, 8740 Chromoly Steel, fits VW Type 4, Porsche 914, and 912E, 1.7, 2.0L, Set of 12. Special order item - please call for availability and lead time before placing your order.Installation Method for Porsche Rod Bolt Kit
Part Number: 104-6006
Application: Porsche 1.7L & 2.0L Type IV Press Fit- Please check the part-number(s) for your application against the part-number(s) listed on the instruction sheet.
- Make sure there is an adequate chamfer around the top of the connecting rod bolt hole to clear the radius under the head of the bolt.
- Press the bolts into the connecting rods and install the rod caps.
- Use ARP Ultra-Torque Fastener Assembly Lubricant to lubricate the threads of the bolt and the nut face. Then install the nuts onto the bolts and tighten them hand tight.
- ARP recommends using the STRETCH METHOD when tightening the bolts. Following the instructions for using a stretch gauge, stretch the bolts to .0055 - .0060.
- If you do not have a stretch gauge, torque the bolts to 40 ft-lbs using ARP Ultra-Torque Fastener Assembly Lubricant.
- The connecting rods should always be re-sized after new rod bolts are installed.
- A log should be kept on the original non-torqued length of each bolt. Bolts that have any permanent deformation or have increased in non-torqued length by more than .001 in. should be replaced.
-
VW Type 4 HD Pressure Plate to Flywheel Bolts
SKU: 10620
$4.30Pressure Plate to Flywheel Bolts - set of 6 Learn More